Product Details
This Whiteline Rear Upper Inner Bushing Offset Camber Kit fits the 2007-2010 Chrysler Sebring (JS). Included: 2 shell bushings and 2 tubes. The part number is KCA329. It goes on the rear of the vehicle. Application note: Adds +/- 0.5 degrees Camber.
Most factory control arm bushings are centered and fixed. An offset one is built so the arm sits at a slightly different angle, which changes camber, and the firmer material stops that setting drifting under load.
Whiteline rates the install as moderate and lists about 3 hours. An alignment is required after installation. We also list Adjustable Rear Sway Bar Link, Front Control Arm Lower Inner Rear Bushing, and Adjustable Front Sway Bar Link for the Sebring.
Features
- Bonded design: The bushing is bonded for strength where loads are highest.
- Finish: Powder coating covers the metal for protection against chips and rust.
- Material: The part is made of polyurethane.
- Bushing compound: A synthetic elastomer compound resists oil, grease, ozone, and weathering.
- Install guide: Step-by-step installation instructions come with it.
- Self-lubricating: Built-in grease reservoirs provide continual lubrication and reduce friction.
Specifications
| Part Number | KCA329 |
| Part Name | Bushing Camber Kit |
| Vehicle | 2007-2010 Chrysler Sebring |
| Chassis Code | JS |
| Bushing 1 Inner Diameter | 12 mm |
| Bushing 1 Outer Diameter | 36.5 mm |
| Bushing 2 Outer Diameter | 36 mm |
| Bushing Quantity | 2 Shell Bushings |
| Grade Type | Performance |
| Inside Diameter | 12 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 2 Shell Bushings, 2 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 36.5 mm |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | Adds +/- 0.5Degree Camber |

