Product Details
This Whiteline Rear Sway Bar Link fits the 2010-2014 Land Rover LR4 HSE. Part number KLC180-115. You receive 2 links. The listing names the HSE trim. Application note: Adjustable Extra Heavy Duty. Placement: rear.
A sway bar link is the short rod that ties each end of the rear sway bar to the suspension. Whenever the body leans, the link carries that motion into the bar, so any slop, flex, or wear in it is slop in the whole roll-control system. Because the length is adjustable, the link can be set on the car so the bar sits relaxed at rest, which matters most after a change in ride height.
Expect a moderate job of about 1 hour. It does not require a wheel alignment. To go with it on the Land Rover LR4, see Front Control Arm Lower Inner Front Bushing.
Features
- Hardware: Hardware supplied: locking nuts and washers.
- Ball joints: Steel ball joint ends are built for heavy loads and free movement.
- Install guide: Step-by-step installation instructions come with it.
- Preload-free setup: The length can be set on the car to remove preload from the sway bar.
- Rigid design: Less flex than the original parts means a quicker, more direct response, especially in lane changes and at initial turn-in.
- Anodized alloy: The alloy carries an anodized finish for durability.
Specifications
| Part Number | KLC180-115 |
| Part Name | Sway Bar Link |
| Vehicle | 2010-2014 Land Rover LR4 HSE |
| Chassis Code | L319 |
| Adjustable | Yes |
| Bolt Thread Diameter | 12 mm |
| Grade Type | Performance |
| Grease Fitting Included | No |
| Greaseable | No |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 1 |
| Kit Contents | 2 Links |
| Length | 110-135 mm |
| Locking Nuts Included | Yes |
| Material | Aluminum Alloy |
| Pre-Greased | No |
| Washers Included | Yes |
| Vehicle Placement | Rear |
| Wheel Alignment Required | No |
| Notes | Adjustable Extra Heavy Duty. Length 110-135mm. Bolt Diameter 12mm. |