Product Details
This Whiteline Rear Upper Inner Bushing Offset Camber Kit fits the 2007-2010 Chrysler Sebring. It is listed for the JS chassis. Included: 2 shell bushings and 2 tubes. The part number is KCA329. It goes on the rear of the vehicle. Application note: Adds +/- 0.5 degrees Camber.
Most factory control arm bushings are centered and fixed. An offset one is built so the arm sits at a slightly different angle, which changes camber, and the firmer material stops that setting drifting under load.
Whiteline rates the install as moderate and lists about 3 hours. An alignment is required after installation. Working on the same car? We also list Adjustable Rear Sway Bar Link, Front Control Arm Lower Inner Rear Bushing, and Adjustable Front Sway Bar Link for the Sebring.
Features
- Bonded design: The bushing is bonded for strength where loads are highest.
- Finish: Powder coating covers the metal for protection against chips and rust.
- Material: The part is made of polyurethane.
- Bushing compound: A synthetic elastomer compound resists oil, grease, ozone, and weathering.
- Install guide: Step-by-step installation instructions come with it.
- Self-lubricating: Built-in grease reservoirs provide continual lubrication and reduce friction.
Specifications
| Part Number | KCA329 |
| Part Name | Bushing Camber Kit |
| Vehicle | 2007-2010 Chrysler Sebring |
| Chassis Code | JS |
| Drivetrain | AWD/FWD |
| Bushing 1 Inner Diameter | 12 mm |
| Bushing 1 Outer Diameter | 36.5 mm |
| Bushing 2 Outer Diameter | 36 mm |
| Bushing Quantity | 2 Shell Bushings |
| Grade Type | Performance |
| Inside Diameter | 12 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 2 Shell Bushings, 2 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 36.5 mm |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | Adds +/- 0.5Degree Camber |