Whiteline Rear Control Arm Bushing Upper - Inner Double Offset Camber Kit for 2013-2016 Scion FR-S (ZN6)

Product Details

This Whiteline Rear Control Arm Bushing Upper - Inner Double Offset Camber Kit fits the 2013-2016 Scion FR-S. Whiteline's note for this fit: On-car adjustable allows +/-0.75 degrees. It goes on the rear of the vehicle. Part number KCA326. You receive 8 bushings, 4 tubes, 8 bolts, 8 washers, and 4 nuts.

A control arm bushing is the pivot where the arm joins the chassis or the wheel carrier. Factory rubber is chosen for quiet and comfort, so it squashes under braking, acceleration, and cornering and lets the arm move more than it should. A firmer replacement keeps the arm where it belongs, which steadies the alignment and gives the car a more consistent feel. The polyurethane used here deflects much less than the original rubber under the same load.

Installation is rated moderate, with about 3 hours of work listed. An alignment is required after installation. To go with it on the FR-S, see Adjustable Rear Sway Bar Link, Front Control Arm Lower Inner Rear Bushing, and 14mm Adjustable Front Camber Bolts.

Features

• Finish: The metal parts are powder coated for durability.
• Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
• Install guide: An install guide comes in the box.
• Anodized alloy: Anodized alloy parts resist corrosion and wear and look good doing it.
• Corrosion protection: Rust protection comes from plating on the metal parts.
• Self-lubricating: Grease reservoirs inside the bushing feed lubrication as it moves.

Specifications