Product Details
This Whiteline Rear Upper Inner Bushing Offset Camber Kit fits the 2008-2017 Mitsubishi Lancer DE, ES. The listing names the DE and ES trims. This part is for the rear of the vehicle. The part number is KCA329. In the box: 2 shell bushings and 2 tubes. Whiteline's note for this fit: Adds +/- 0.5 degrees Camber. The chassis code on the listing is CY.
Camber is the sideways lean of the wheel when viewed from the front. An offset control arm bushing places the pivot slightly off-center, which shifts the wheel's camber by a small, fixed amount without replacing the arm. On a lowered car that is often enough to bring the tires back toward an even footprint.
Whiteline rates the install as moderate and lists about 3 hours. Get the car aligned once it is back on the ground. Working on the same car? We also list Adjustable Rear Sway Bar Link, Front Control Arm Lower Inner Rear Bushing, and 14mm Adjustable Front Camber Bolts for the Lancer.
Features
- Material: The part is made of polyurethane.
- Install guide: Instructions for fitting are packed in the box.
- Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
- Finish: The metal is powder coated, which resists corrosion and wear.
- Bonded design: The bushing is bonded for strength where loads are highest.
- Self-lubricating: Internal grease reservoirs keep the bushing lubricated as it works.
Specifications
| Part Number | KCA329 |
| Part Name | Bushing Camber Kit |
| Vehicle | 2008-2017 Mitsubishi Lancer DE, ES |
| Chassis Code | CY |
| Drivetrain | AWD/FWD |
| Bushing 1 Inner Diameter | 12 mm |
| Bushing 1 Outer Diameter | 36.5 mm |
| Bushing 2 Outer Diameter | 36 mm |
| Bushing Quantity | 2 Shell Bushings |
| Grade Type | Performance |
| Inside Diameter | 12 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 2 Shell Bushings, 2 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 36.5 mm |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | Adds +/- 0.5Degree Camber |