Product Details
This Whiteline Rear Sway Bar Link fits the 2005-2008 Land Rover LR3 SE (L319). Whiteline part number: KLC180-115. Whiteline's note for this fit: Adjustable Extra Heavy Duty. The kit contains 2 links. This part is for the rear of the vehicle.
A sway bar link is the short rod that ties each end of the rear sway bar to the suspension. Whenever the body leans, the link carries that motion into the bar, so any slop, flex, or wear in it is slop in the whole roll-control system. Because the length is adjustable, the link can be set on the car so the bar sits relaxed at rest, which matters most after a change in ride height.
Installation is rated moderate, with about 1 hour of work listed. It does not require a wheel alignment. To go with it on the Land Rover LR3, see Front Control Arm Lower Inner Front Bushing and Rear Control Arm Lower Front Bushing.
Features
- Ball joints: Steel ball joint ends handle the loads and rotate to suit the car's geometry.
- Construction: High-strength alloy gives the strength needed without much weight.
- Install guide: An install guide comes in the box.
- Preload-free setup: Setting the length on the car lets the bar rest without preload.
- Anodized alloy: Anodized alloy parts resist corrosion and wear and look good doing it.
- Rigid design: Built to remove the flex found in factory parts, so inputs reach the bar sooner.
Specifications
| Part Number | KLC180-115 |
| Part Name | Sway Bar Link |
| Vehicle | 2005-2008 Land Rover LR3 SE |
| Chassis Code | L319 |
| Drivetrain | 4WD |
| Adjustable | Yes |
| Bolt Thread Diameter | 12 mm |
| Grade Type | Performance |
| Grease Fitting Included | No |
| Greaseable | No |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 1 |
| Kit Contents | 2 Links |
| Length | 110-135 mm |
| Locking Nuts Included | Yes |
| Material | Aluminum Alloy |
| Pre-Greased | No |
| Washers Included | Yes |
| Vehicle Placement | Rear |
| Wheel Alignment Required | No |
| Notes | Adjustable Extra Heavy Duty. Length 110-135mm. Bolt Diameter 12mm. |

