Product Details

This Whiteline Rear Upper Inner Bushing Offset Camber Kit fits the 2012 Mitsubishi Lancer SE (CY). Application note: Adds +/- 0.5 degrees Camber. Part number KCA329. Placement: rear. You receive 2 shell bushings and 2 tubes.

Camber is the sideways lean of the wheel when viewed from the front. An offset control arm bushing places the pivot slightly off-center, which shifts the wheel's camber by a small, fixed amount without replacing the arm. On a lowered car that is often enough to bring the tires back toward an even footprint.

Installation is rated moderate, with about 3 hours of work listed. Get the car aligned once it is back on the ground. To go with it on the Lancer, see Adjustable Rear Sway Bar Link, Front Control Arm Lower Inner Rear Bushing, and 14mm Adjustable Front Camber Bolts.

Features

  • Finish: Powder coat finish guards the metal against chips and corrosion.
  • Bonded design: The bushing is bonded for extra strength under heavy loads.
  • Corrosion protection: Metal parts are plated to resist rust over the long term.
  • Material: Built from polyurethane.
  • Install guide: An install guide comes in the box.
  • Bushing compound: The bushing material stands up to oil, grease, ozone, and weather.
Specifications
Part Number KCA329
Part Name Bushing Camber Kit
Vehicle 2012 Mitsubishi Lancer SE
Chassis Code CY
Drivetrain AWD/FWD
Bushing 1 Inner Diameter 12 mm
Bushing 1 Outer Diameter 36.5 mm
Bushing 2 Outer Diameter 36 mm
Bushing Quantity 2 Shell Bushings
Grade Type Performance
Inside Diameter 12 mm
Installation Difficulty Moderate
Installation Time (hrs) 3
Kit Contents 2 Shell Bushings, 2 Tubes
Material Polyurethane
Mounting Hardware Included No
Outside Diameter 36.5 mm
Vehicle Placement Rear
Wheel Alignment Required Yes
Notes Adds +/- 0.5Degree Camber

Vehicle fitment

This product fits the vehicles listed below.

YearMakeModelDrivetrainNotes
2012MitsubishiLancerAWDAdds +/- 0.5Degree Camber
2012MitsubishiLancerFWDAdds +/- 0.5Degree Camber

Customer Reviews

Questions & Answers