Product Details
This Whiteline Rear Control Arm Upper Front Bushing (Standard Repl.) fits the 2006 Dodge Charger Daytona R/T (LX). You receive 4 shell bushings, 4 tubes, and 2 washers. Whiteline's note for this fit: Standard Replacements. Qty 2 needed per vehicle. It goes on the rear of the vehicle. The part number is W63340.
When a control arm bushing fails, the wheel is no longer held where it should be under braking and over bumps. This is a like-for-like replacement: it restores the original pivot behavior and ride comfort rather than changing them.
Installation is rated moderate, with about 3 hours of work listed. Get the car aligned once it is back on the ground. Other Whiteline parts we list for the Charger: Front and Rear Sway Bar Kit, Rear Subframe Mount Bushing, and Front Sway Bar Link Kit.
Features
- Install guide: Written install instructions are included with the part.
- Bonded design: The bushing is bonded for strength where loads are highest.
- Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
- Finish: Powder coat finish guards the metal against chips and corrosion.
- Self-lubricating: The bushing carries its own grease supply in internal reservoirs, so it keeps moving freely.
- Corrosion protection: Rust protection comes from plating on the metal parts.
Specifications
| Part Number | W63340 |
| Part Name | Control Arm Bushing |
| Vehicle | 2006 Dodge Charger Daytona R/T |
| Drivetrain | RWD |
| Chassis Code | LX |
| Bushing 1 Inner Diameter | 12.2 mm |
| Bushing 1 Outer Diameter | 39.5 mm |
| Bushing Quantity | 4 Shell Bushings |
| Grade Type | Regular |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 4 Shell Bushings, 4 Tubes, 2 Washers |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | Standard Replacements. Qty 2 needed per vehicle. |



