Product Details

This Whiteline Rear Control Arm Upper Front Bushing fits the 2009-2011 Dodge Challenger SE (LC). Order it as part number W63342. Whiteline's note for this fit: Adds +/- 0.5 degrees Camber. Qty 2 needed per vehicle. This part is for the rear of the vehicle. Included: 4 shell bushings and 4 tubes.

Lowering a car or fitting wider tires can push camber out of the range an alignment shop can correct with factory parts. This offset bushing moves the arm's pivot point to give the technician more to work with, while also replacing the soft rubber that was there.

Whiteline rates the install as moderate and lists about 3 hours. Plan on a wheel alignment afterward. To go with it on the Challenger, see Rear Subframe Mount Bushing, Front Sway Bar Link Kit, and Front and Rear Sway Bar Kit.

Features

  • Material: Made from polyurethane.
  • Install guide: Instructions for fitting are packed in the box.
  • Bonded design: The bushing is bonded for extra strength under heavy loads.
  • Self-lubricating: Grease reservoirs inside the bushing feed lubrication as it moves.
  • Grease: Molybdenum disulfide grease comes with it for a longer service life.
  • Bushing compound: A synthetic elastomer compound resists oil, grease, ozone, and weathering.
Specifications
Part Number W63342
Part Name Control Arm Bushing
Vehicle 2009-2011 Dodge Challenger SE
Chassis Code LC
Bushing 1 Inner Diameter 12.2 mm
Bushing 1 Outer Diameter 39.5 mm
Bushing 2 Inner Diameter 12.2 mm
Bushing Quantity 4 Shell Bushings
Grade Type Regular
Installation Difficulty Moderate
Installation Time (hrs) 3
Kit Contents 4 Shell Bushings, 4 Tubes
Material Polyurethane
Mounting Hardware Included No
Vehicle Placement Rear
Wheel Alignment Required Yes
Notes Adds +/- 0.5Degree Camber. Qty 2 needed per vehicle.

Vehicle fitment

This product fits the vehicles listed below.

YearMakeModelDrivetrainNotes
2009DodgeChallengerRWDAdds +/- 0.5Degree Camber. Qty 2 needed per vehicle.
2010DodgeChallengerRWDAdds +/- 0.5Degree Camber. Qty 2 needed per vehicle.
2011DodgeChallengerRWDAdds +/- 0.5Degree Camber. Qty 2 needed per vehicle.

Customer Reviews

Questions & Answers