Product Details

This Whiteline Rear Upper Outer Control Arm Bushing Kit fits the 1986-1990 Mazda RX-7 GXL (FC). Whiteline's note for this fit: To hub adds +/- 1.5 degrees Camber. You receive 4 bushings and 2 tubes. Position: rear. Whiteline part number: KCA379.

Most factory control arm bushings are centered and fixed. An offset one is built so the arm sits at a slightly different angle, which changes camber, and the firmer material stops that setting drifting under load.

Whiteline rates the install as moderate and lists about 2 hours. Get the car aligned once it is back on the ground. To go with it on the RX-7, see 12mm Adjustable Front Camber Bolts, Front Control Arm Lower Inner Front Bushing, and Tie Rod Boot Kit.

Features

  • Self-lubricating: Built-in grease reservoirs provide continual lubrication and reduce friction.
  • Grease: Supplied with molybdenum disulfide grease for extended service life.
  • Finish: Powder coating covers the metal for protection against chips and rust.
  • Corrosion protection: The hardware is plated to stand up to road conditions.
  • Bushing compound: A synthetic elastomer compound resists oil, grease, ozone, and weathering.
  • Material: Built from polyurethane.
Specifications
Part Number KCA379
Part Name Control Arm Bushing
Vehicle 1986-1990 Mazda RX-7 GXL
Chassis Code FC
Bushing 1 Inner Diameter 12.2 mm
Bushing 1 Outer Diameter 36 mm
Bushing Quantity 4 Bushings
Grade Type Performance
Inside Diameter 10.2 mm
Installation Difficulty Moderate
Installation Time (hrs) 2
Kit Contents 4 Bushings, 2 Tubes
Material Polyurethane
Mounting Hardware Included No
Outside Diameter 36 mm
Vehicle Placement Rear
Wheel Alignment Required Yes
Notes To hub adds +/- 1.5Degree Camber

Vehicle fitment

This product fits the vehicles listed below.

YearMakeModelDrivetrainNotes
1986MazdaRX-7RWDTo hub adds +/- 1.5Degree Camber
1987MazdaRX-7RWDTo hub adds +/- 1.5Degree Camber
1988MazdaRX-7RWDTo hub adds +/- 1.5Degree Camber
1989MazdaRX-7RWDTo hub adds +/- 1.5Degree Camber
1990MazdaRX-7RWDTo hub adds +/- 1.5Degree Camber

Customer Reviews

Questions & Answers