Product Details
This Whiteline Front Sway Bar Link Bushing Kit fits the 1987-1991 Chevrolet Blazer 4WD. Position: front. In the box: 6 bushings, 2 tubes, grease, and an install guide. This listing is for 4WD models. The part number is W23812.
The bar can only resist roll as well as its links are attached. A worn link bushing adds slack that the bar must take up before it works, so replacing it is a low-cost way to bring back sharp response.
Expect a moderate job of about 1 hour. A wheel alignment is not required. To go with it on the Blazer, see Body Mount Bushing Kit, Tie Rod Boot Kit, and Transmission Mount Bushing.
Features
- Grease: Supplied with molybdenum disulfide grease for extended service life.
- Install guide: An install guide comes in the box.
- Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
- Easy to fit: Made with the installer in mind, so it goes in without special equipment.
- Self-lubricating: Grease reservoirs inside the bushing feed lubrication as it moves.
Specifications
| Part Number | W23812 |
| Part Name | Sway Bar Link Bushings |
| Vehicle | 1987-1991 Chevrolet Blazer |
| Chassis Code | GMT400 |
| Drivetrain | 4WD |
| Grade Type | Regular |
| Grease Fitting Included | No |
| Inside Diameter | 22.2 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 1 |
| Kit Contents | 6 Bushings, 2 Tubes, Grease, Install Guide |
| Mounting Hardware Included | No |
| Vehicle Placement | Front |
| Wheel Alignment Required | No |
| Notes | - |