Product Details

This Whiteline Front Sway Bar Link fits the 1965-1970 Ford Mustang Shelby GT-350 (Fox). Included: 2 links, 8 bushings, 8 washers, and 8 nuts. Placement: front. Part number W21807S.

A sway bar link is the short rod that ties each end of the front sway bar to the suspension. Whenever the body leans, the link carries that motion into the bar, so any slop, flex, or wear in it is slop in the whole roll-control system.

Expect an easy job of about 1 hour. A wheel alignment is not required. To go with it on the Mustang, see Front Sway Bar Washer Kit, Tie Rod Boot Kit, and Front Lower Control Arm Bushing Kit.

Features

  • Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
  • Corrosion protection: Plated finish keeps rust off the hardware.
  • Rigid design: Less flex than the original parts means a quicker, more direct response, especially in lane changes and at initial turn-in.
  • Install guide: Written install instructions are included with the part.
  • Bushing material: Polyurethane is firmer than the factory rubber, so it deflects less under load.
Specifications
Part Number W21807S
Part Name Sway Bar Link
Vehicle 1965-1970 Ford Mustang Shelby GT-350
Drivetrain RWD
Chassis Code Fox
Bolt Thread Diameter 10 mm
Bushing Material Polyurethane
Grade Type Performance
Installation Difficulty Easy
Installation Time (hrs) 1
Kit Contents 2 Links, 8 Bushings, 8 Washers, 8 Nuts
Length 130-160 mm
Vehicle Placement Front
Wheel Alignment Required No
Notes -

Vehicle fitment

This product fits the vehicles listed below.

YearMakeModelDrivetrainNotes
1965FordMustangRWD
1966FordMustangRWD
1967FordMustangRWD
1968FordMustangRWD
1969FordMustangRWD
1970FordMustangRWD

Customer Reviews

Questions & Answers