Product Details
This Whiteline Front Upper Control Arm Bushing Kit fits the 1989-1995 Honda Civic Si (EF/EG). Placement: front. In the box: 4 bushings and 4 tubes. Part number KCA378.
A control arm bushing is the pivot where the arm joins the chassis or the wheel carrier. Factory rubber is chosen for quiet and comfort, so it squashes under braking, acceleration, and cornering and lets the arm move more than it should. A firmer replacement keeps the arm where it belongs, which steadies the alignment and gives the car a more consistent feel. The polyurethane used here deflects much less than the original rubber under the same load.
Installation is rated moderate, with about 3 hours of work listed. Plan on a wheel alignment afterward. To go with it on the Civic Si, see Front Sway Bar Link Bushing (28.5mm OD), Rear Sway Bar Link Bushing (28.5mm OD), and Rear Control Arm Upper Bolt Kit.
Features
- Finish: The metal is powder coated, which resists corrosion and wear.
- Self-lubricating: The bushing carries its own grease supply in internal reservoirs, so it keeps moving freely.
- Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
- Camber adjustment: Helps hold the tire flatter on the road by correcting camber changes through roll.
- Corrosion protection: A protective plating covers the metal components to guard against corrosion.
- Material: Built from polyurethane.
Specifications
| Part Number | KCA378 |
| Part Name | Control Arm Bushing |
| Vehicle | 1989-1995 Honda Civic Si |
| Drivetrain | FWD |
| Chassis Code | EF/EG |
| Bushing 1 Inner Diameter | 10.2 mm |
| Bushing 1 Outer Diameter | 34.4 mm |
| Bushing Quantity | 4 Bushings |
| Grade Type | Performance |
| Inside Diameter | 12.2 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 4 Bushings, 4 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 34.4 mm |
| Vehicle Placement | Front |
| Wheel Alignment Required | Yes |
| Notes | 34mm OD bushing adds 1.0 Degrees |


