Product Details
This Whiteline Front Upper Control Arm Bushing Kit fits the 1988 Honda CR-X DX (EF). Included: 4 bushings and 4 tubes. Placement: front. Order it as part number KCA378.
A control arm bushing is the pivot where the arm joins the chassis or the wheel carrier. Factory rubber is chosen for quiet and comfort, so it squashes under braking, acceleration, and cornering and lets the arm move more than it should. A firmer replacement keeps the arm where it belongs, which steadies the alignment and gives the car a more consistent feel. The polyurethane used here deflects much less than the original rubber under the same load.
Whiteline rates the install as moderate and lists about 3 hours. Plan on a wheel alignment afterward. To go with it on the CR-X, see Adjustable Rear Upper Control Arm Set, Front Sway Bar Link Kit, and Front Sway Bar Link Bushing (28.5mm OD).
Features
- Grease: Supplied with molybdenum disulfide grease for extended service life.
- Material: The part is made of polyurethane.
- Corrosion protection: Rust protection comes from plating on the metal parts.
- Finish: Powder coating covers the metal for protection against chips and rust.
- Self-lubricating: The bushing carries its own grease supply in internal reservoirs, so it keeps moving freely.
- Bushing compound: The bushing material stands up to oil, grease, ozone, and weather.
Specifications
| Part Number | KCA378 |
| Part Name | Control Arm Bushing |
| Vehicle | 1988 Honda CR-X DX |
| Chassis Code | EF |
| Bushing 1 Inner Diameter | 10.2 mm |
| Bushing 1 Outer Diameter | 34.4 mm |
| Bushing Quantity | 4 Bushings |
| Grade Type | Performance |
| Inside Diameter | 12.2 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 3 |
| Kit Contents | 4 Bushings, 4 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 34.4 mm |
| Vehicle Placement | Front |
| Wheel Alignment Required | Yes |
| Notes | 34mm OD bushing adds 1.0 Degrees |



