Product Details
This Whiteline Rear Upper Outer Control Arm Bushing Kit fits the 1988 Mazda RX-7 10th Anniversary, SE, SE 2+2 (FC). Included: 4 bushings and 2 tubes. Placement: rear. Application note: To hub adds +/- 1.5 degrees Camber. The part number is KCA379. Chassis code: FC.
Lowering a car or fitting wider tires can push camber out of the range an alignment shop can correct with factory parts. This offset bushing moves the arm's pivot point to give the technician more to work with, while also replacing the soft rubber that was there.
Installation is rated moderate, with about 2 hours of work listed. Get the car aligned once it is back on the ground. Other Whiteline parts we list for the RX-7: 12mm Adjustable Front Camber Bolts, Front Control Arm Lower Inner Front Bushing, and Tie Rod Boot Kit.
Features
- Camber adjustment: Designed to optimize camber alignment and offset the effect of body roll and tire roll in corners.
- Grease: Moly grease is supplied to prolong the life of the parts.
- Bushing compound: A synthetic elastomer compound resists oil, grease, ozone, and weathering.
- Corrosion protection: The hardware is plated to stand up to road conditions.
- Finish: The metal parts are powder coated for durability.
- Self-lubricating: Grease reservoirs inside the bushing feed lubrication as it moves.
Specifications
| Part Number | KCA379 |
| Part Name | Control Arm Bushing |
| Vehicle | 1988 Mazda RX-7 10th Anniversary, SE, SE 2+2 |
| Chassis Code | FC |
| Bushing 1 Inner Diameter | 12.2 mm |
| Bushing 1 Outer Diameter | 36 mm |
| Bushing Quantity | 4 Bushings |
| Grade Type | Performance |
| Inside Diameter | 10.2 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 2 |
| Kit Contents | 4 Bushings, 2 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 36 mm |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | To hub adds +/- 1.5Degree Camber |