Product Details
This Whiteline Rear Upper Outer Control Arm Bushing Kit fits the 1988-1991 Mazda RX-7 Convertible (FC). Position: rear. Application note: To hub adds +/- 1.5 degrees Camber. In the box: 4 bushings and 2 tubes. The part number is KCA379.
Camber is the sideways lean of the wheel when viewed from the front. An offset control arm bushing places the pivot slightly off-center, which shifts the wheel's camber by a small, fixed amount without replacing the arm. On a lowered car that is often enough to bring the tires back toward an even footprint.
Expect a moderate job of about 2 hours. Plan on a wheel alignment afterward. Other Whiteline parts we list for the RX-7: 12mm Adjustable Front Camber Bolts, Front Control Arm Lower Inner Front Bushing, and Tie Rod Boot Kit.
Features
- Self-lubricating: The bushing carries its own grease supply in internal reservoirs, so it keeps moving freely.
- Grease: Supplied with molybdenum disulfide grease for extended service life.
- Corrosion protection: Metal parts are plated to resist rust over the long term.
- Material: Built from polyurethane.
- Finish: The metal parts are powder coated for durability.
- Bushing compound: Oil, grease, ozone, and weather do not break down the synthetic elastomer used in the bushings.
Specifications
| Part Number | KCA379 |
| Part Name | Control Arm Bushing |
| Vehicle | 1988-1991 Mazda RX-7 Convertible |
| Chassis Code | FC |
| Bushing 1 Inner Diameter | 12.2 mm |
| Bushing 1 Outer Diameter | 36 mm |
| Bushing Quantity | 4 Bushings |
| Grade Type | Performance |
| Inside Diameter | 10.2 mm |
| Installation Difficulty | Moderate |
| Installation Time (hrs) | 2 |
| Kit Contents | 4 Bushings, 2 Tubes |
| Material | Polyurethane |
| Mounting Hardware Included | No |
| Outside Diameter | 36 mm |
| Vehicle Placement | Rear |
| Wheel Alignment Required | Yes |
| Notes | To hub adds +/- 1.5Degree Camber |